Network ion fan air gun nozzle maintenance method

First, the network ion fan air gun nozzle maintenance methods

1, power supply, air supply requirements

① power must have ground, and to ensure adequate grounding. The transformer must be properly grounded, and check the ground wire knob for tightening before each use.

② the gas used must be effectively filtered. Sometimes the secondary filter is needed. The filter should be cleaned in time. Otherwise: water, oil and dust / dust particles will enter the ionization chamber and attach to the inner wall of the plastic part. Accumulated to a certain extent, the ion needle will be on its ignition. As a result, the plastic parts gradually formed honeycomb-shaped focal loss, and the ion excretion gradually decreased; in particular, there was a security risk.

③ to cooperate with my company's power supply, do not buy fake.

2, in addition to static effect adjustment

In addition to static electricity in addition to static electricity and air pressure is inversely proportional. The pressure should be 0.3Mpa-0.7Mpa.

② the tip of the gun, the mouth of the nozzle and the distance between the electrostatic field, the angle of the effect of static electricity should be noted that until the satisfaction of debugging.

3, routine maintenance

① air gun / wind mouth easy to break. When the wind gun used to pay attention to anti-collision, after use to pay attention to drop. Even if the fixed installation of the nozzle, but also pay attention to prevent the collision of objects.

② air gun pressure regulating valve is moderate, the amount of point into the universal anti-rust lubricant.

③ clean sailor nozzle ion needle and ion needle room to use anhydrous alcohol can not use the day to take water. When cleaning, first power off, and then use the son of the wind gun head in front of a small plastic cover (also known as air accelerator) unscrewed, with a cotton swab stained with anhydrous alcohol to clean the ion needle and ion needle chamber chamber, inside the inside Stains, dirt clean.

④ air gun nozzle to the best foot pedal switch, or through the solenoid valve and mechanical action linkage control, both to improve the use of results, but also extend the service life.

4, see the other instructions

5, pay attention to

① ion air gun, the nozzle is a sophisticated, sensitive in addition to static products. Must meet the conditions of use!

② not to ground power, unclean gas source conditions, and do not care to use the resulting failure, damage and other consequences are not in the Division I warranty and the scope of responsibility.

Second, the retreat maintenance of the wind gun nozzle are mostly 05 years, due to the long-term high-voltage line in the role of high electric field is easy old

It is time to change. Wind gun my company has long launched the SL-004D new, durable and durable, more secure and reliable.

Third, the high-voltage power supply detection, use high-voltage meter detection. Simple detection as long as the high-voltage output arc can determine whether the high-voltage output. As for its performance depends on the use of high voltage voltage detection. At the same time, respectively, with 500P.1000P.1500P capacitor, observe the output voltage changes. The smaller the voltage changes the better.